# Analog Functionality in Truss Studio

**Overview**

Analogs are determined by the program automatically based on user input. While some EnvData settings have an effect on analogs, only those users with Truss Studio engineering permissions are allowed to change those settings.

In most cases, bad analogs typically result from erroneous or unexpected user input. You can remedy problems by providing the correct/expected input. This may vary, depending on the specific truss and the specific analog issue. In rare instances, there may be an issue with the software itself.

Possible Causes

Some situations that may result in erroneous analogs:

- Analog lines that go astray (not even close to following a physical member).
- Analog lines that extend through the end points of members, or that are short of the end points of members (typically happens after unexpected trim commands are used that change end joint locations).
- Missing analog lines (a physical member that is not represented by an analog line). Note that if a member is marked as non-structural (webs only), there is no intentional analog line.
- Physical members that touch each other but do not create an analog joint connection; typically this results in a no-plate solution since the application doesn’t consider that as a joint. An unplated joint error will not occur because Truss Studio doesn’t recognize that the joint should exist.
- Analog bearings that don’t represent the condition, including missing analog bearings (indicated by a solid-color triangle at a node near the physical location of the bearing).
- Any other conditions that look suspicious.


![](/images/csdirector-cstruss/resources/images/note-onlinehelp.png) **Note:** Most analog issues result in a failed truss. A matrix error or an excessive deflection error may display, or the truss will fail to process at all. Check the Status Messages box in the Input screen, as well as the Errors tab after analysis for messages that might indicate the nature of the problem.

For questions or help reviewing suspected issues, contact Simpson Strong-Tie Support.