# Best practices for efficient truss design

The following are suggested best practices for truss design:

- Use Undo whenever possible if a problem occurs or if you do not get the desired result; do not continue with the design. This limits unnecessary Additional Commands.
- Use Profile command lines (including Web) as much as possible to achieve the initial design; don’t change profile lines after using Additional Commands.
- If using Save As after using Additional Commands, it is generally best to delete those commands before making any changes to span and profile.
- Use available dialogs to make changes rather than using Additional Commands.
- Use Shadow Truss to “line up” webs for bracing, match geometry for batching; verify that side-by-side trusses look as desired.
- Use the enhanced Match Left and Match Right options to get symmetrical designs (as much as possible) and enable the **EnvData > Analysis> OverallControls** options for symmetry to get a symmetrically designed and plated truss to avoid backward installs.
- Verify loading conditions. Load Transfers and other loading options are critical tools to use, but always double-check loading options.
- Set the **EnvData> UserInterface > DisplayControl > Display Additional Commands Step Controls** option to review each Additional Command; this tool is very useful for investigating how a design was created. See [Review Additional Commands](/csdirector-cstruss/help-center/design-view/review-additional-commands).
- Set the **EnvData > UserInterface > Show the Load Combination Edit dialog as list** to True to use the List View for Load Combinations. This allows viewing of **all** loads used in a combination at once. See [View and Edit Load Combinations](/csdirector-cstruss/help-center/design-view/loading/view-edit-load-combinations)


![](/images/csdirector-cstruss/resources/images/ts-loadcombos-bestpractices.png)