# Create Work Line (with Heel Height & Roof Plane)

**Purpose**

Allows you to create roof and ceiling planes using a work line.

**Prerequisites**

A layout

**Steps**

**Create a work line with a heel height and a roof plane**

1. Select one of the reference line commands. Any of the reference line commands will work (Parallel, Through Pt - Par, Through Pt - Perp or Through 2 Points).


The caption bar displays the steps required to create the reference line. (These steps will vary depending on which command was selected in Step 1.)

1. Follow the steps displayed in the caption bar. If the caption bar is not visible, go to **Application** > **Caption Bar** to make sure the caption bar is enabled.


A reference line is created. After you create a reference line, Truss Studio automatically enters Work line mode.

1. To create a work line, drag a line across the reference line.
2. Select the newly created work line.


The work line properties display in the Properties window.   ![](/images/csdirector-cstruss/resources/images/wlpropertiesb4roofplane-227x236.png) ![](/images/csdirector-cstruss/resources/images/wlheelheightoptions-220x189.png)

1. Select or input a heel height and roof pitch in the Properties window.


The roof plane input is displayed in the **Roof Plane** field and the current heel height displays in the **Heel Height** field. The roof plane is displayed on the work line in the layout space.

![](/images/csdirector-cstruss/resources/images/note-onlinehelp.png)**Notes:**

- The current heel height is the same as the heel height displayed if you selected Settings on the Layout Commands toolbar and viewed the Heel Height options.
- You can change work line properties (elevation, heel height, roof and ceiling planes) at any time.
- Zero can also be selected for the heel height of work lines that have roof planes associated with them.
- The heel height does not have an effect on the ceiling plane. If a ceiling plane is added to the work line the ceiling plane will be created at the same elevation as the work line.
- The plane on the work line points in the direction that you dragged the line across the reference line in step #3.


![](/images/csdirector-cstruss/resources/images/wlpropertiesroofplane-256x267.png) ![](/images/csdirector-cstruss/resources/images/setttingsupdated-311x300.png)

**Direction of the roof plane**

![](/images/csdirector-cstruss/resources/images/directionofplane-260x315.png)