# Special Cuts on Odd Length Webs

**Purpose**

You can apply single or square cuts on shorter or odd length webs by applying an EnvData setting. Because shorter webs may cause saw blades to clash, the ability to single cut with the angles going in the same direction may help prevent this issue.

**Steps**

1. Navigate to **EnvData > Geometry Controls > Special-cut ends of Wx2 odd diagonals setting**.
2. Select **None**, **Single-cut**, or **Square-cut**.


Examples are provided below.

![](/images/csdirector-cstruss/resources/images/ts-oddlength-specialcut-single-1093x394.jpg)

![](/images/csdirector-cstruss/resources/images/ts-squarecutwebs2023r1-1093x265.png)

![](/images/csdirector-cstruss/resources/images/ts-oddlength-specialcut-none-1081x412.jpg)

![](/images/csdirector-cstruss/resources/images/note-onlinehelp.png) **Note**: You can also change the setting for the selected web in the **Properties** pane.

![](/images/csdirector-cstruss/resources/images/ts-specialcutends.png)

**Related Topics**

[Square Cut Webs on Floor/Roof Trusses](/csdirector-cstruss/help-center/design-view/square-cut-webs-on-floor-trusses)