# Square Cut Webs on Floor/Roof Trusses

**Purpose**

Easily square cut webs on parallel chord floor (or roof) trusses and non-parallel chords/webs.

**Steps**

**For square cut webs and chords (parallel chord trusses)**

![](/images/csdirector-cstruss/resources/images/video-icon-39x40.png) Watch video

1. Open the floor or roof truss. This example uses a floor truss.


![](/images/csdirector-cstruss/resources/images/d-floortruss.png)

1. Navigate to **EnvData > Geometry > Geometry Controls > Square-cut floor webs (Parallel chord truss only)**.
2. From the drop down, select **True** to enable the setting.


The webs are square-cut.

1. To plate the joints, click **Run.**


Note that square-cut joints result in larger plates due to less wood-to-wood contact at the joints.

For square cut webs and chords (non-parallel chord trusses)

![](/images/csdirector-cstruss/resources/images/video-icon-39x40.png) **Watch Video**

- Note that you must have Engineering rights to use this setting.
- Overhangs are not impacted by this setting. Square cut overhangs can be defined in the Overhang - Left and Right dialogs.


1. Navigate to **EnvData > Geometry > Geometry Controls > Square-cut members (Non-parallel chord trusses)**.
2. Select one of the following from the drop down list displayed:


- None
- Chords
- Webs
- Chords and Webs


When **None** is selected:

- The settings from Square-cut floor webs (Parallel chord truss only) take priority.
- The settings from Square-cut roof webs (Parallel chord truss only) take priority.


**Related Topics**

[Special Cuts on Odd Length Webs](/csdirector-cstruss/help-center/design-view/single-square-cut-webs)