# Tail-Bearing Trusses - Dead Load

**Purpose**

Truss Studio can load truss overhangs for soffit framing and other typical conditions. When Bearings and/or Fillers are applied to overhangs, it is important to define the proper design loading at the overhangs.

**Note:** Bottom chord loading is applied to the underside of top chords when a bearing is applied to an overhang. When a Filler is applied to a tail-bearing truss, the soffit load defined in the Template Manager is automatically applied; you must verify that this is the desired result.

**Steps**

The following example uses a 8’-0” truss with 5’-0” overhangs. Standard loading is 20/10/0/10.

1. Create a tail-bearing truss.


Note the allocation of dead loads on the top and bottom chords.

![](/images/csdirector-cstruss/resources/images/ts-tailbearingtruss-example1.png)

1. If required, add[Add Filler](/csdirector-cstruss/help-center/design-view/edit-joints/add-filler) members to the overhang(s) and apply any necessary blocking with the [Add Board](/csdirector-cstruss/help-center/design-view/add-board) function. Adjust [Add Bearings](/csdirector-cstruss/help-center/design-view/bearings/bearings), as necessary.


Note the different allocation of dead loads on the top and bottom chords with Filler members added.

![](/images/csdirector-cstruss/resources/images/ts-tailbearingtruss-filler.png)

Two possible dead load adjustments are shown below.

Option 1

1. In **Load Template Manager**, select **Std Load**.
2. Set the **Soffit Load psf** to 10 psf.


![](/images/csdirector-cstruss/resources/images/ts-tailbearingtruss-soffit-dead-load.png)

Option 2

1. In **Load Template Manager**, select **Std Load**.
2. Set the **Soffit Load psf** to 0 psf.
3. On the **Component Loading** dialog, select **Load Profile**.


![](/images/csdirector-cstruss/resources/images/ts-componentloading-dialog-loadprofilebutton.png)

1. Adjust the **TC Profile** to reflect the overall desired load profile.


![](/images/csdirector-cstruss/resources/images/ts-tailbearingtruss-load-profile.png)

**Related Topics**