# Use Generic Trimmable Ends for Floor Trusses

**Purpose**

Design floor trusses with ends that are trimmable, so floor trusses can be cut to the exact length in the field.

For floor truss trimmable end inserts Truss Studio currently supports EverTrim, TrimFit, I-Block, I-Joists products, OSB, and vertically oriented 2x12 inserts. Vertically oriented 2x12 trimmable end inserts were added recently. This feature supports another 'generic' trimmable end insert made of vertically oriented 2x6's, 2x8's, and 2x10's.

Floor Truss Depths include:

12" (9" insert)

14" (11" insert)

16" (13" insert)

18" (15" insert)

Currently for lumber, when designing a truss, Truss Studio bumps through lumber in the order specified by the user in the Material Selection Priority list, and Truss Studio will try each material until it finds one that works for the condition. For trimmable end inserts, Truss Studio finds the first in the Material Selection Priority list that fits the floor truss geometry (width and depth), designs the truss with that, and will not try any other trimmable inserts if the first in the list that fits fails. Also users cannot override the trimmable insert selection. These limitations were fine in the past because the trimmable inserts that were supported by Truss Studio only had one product that would fit any given truss geometry. But now Truss Studio supports 2x (dimensional lumber) trimmable inserts that have multiple products that can fit any given truss geometry.

**Prerequisites**

An existing floor truss

**Steps**

1. On the End Conditions dialog, select the trimmable insert size from the drop down list.


![](/images/csdirector-cstruss/resources/images/ts-trimmableenddropdown.png)

The insert size is adjusted.

**Related Topics**