# Match Left / Match Right

**Purpose**

Match Left / Match Right allow you to duplicate the left or right side of a truss on the opposite side of the truss, instead of designing the entire truss.

**Steps**

![](/images/csdirector-cstruss/resources/images/video-icon.png) Watch video

1. After designing the left or right half of a truss, select **Match Left** or **Match Right** on the **Operations** menu, or click the **Match Left** ![](/images/csdirector-cstruss/resources/images/ts-matchleft-icon.png) or **Match Right** ![](/images/csdirector-cstruss/resources/images/ts-matchrt-icon.png) icon on the toolbar.


The side of the truss is duplicated on the left or right side, depending on the command selected; this includes structural members. Non-structural members are not duplicated. In the example below, the Match Left command was used to duplicate the truss on the right side.

![](/images/csdirector-cstruss/resources/images/ts-matchleft-1.png)

![](/images/csdirector-cstruss/resources/images/ts-matchleft-2.png)

After using the Match commands, you can automatically adjust plates and lumber grade/species for a symmetrical truss. See the settings to automatically update plates/lumber in [Overall Controls](/csdirector-cstruss/help-center/truss-studio-online-help/env-data-settings/overall-controls-settings).

When these settings are applied to a geometrically symmetrical truss, a message displays on the TDD.

![](/images/csdirector-cstruss/resources/images/ts-symmetrictruss-message-1259x405.png)

If you try to apply these settings to a truss that is not geometrically symmetrical, a warning note displays on the TDD and on the truss design. This also indicates that the truss cannot be installed backwards (reversed).

![](/images/csdirector-cstruss/resources/images/ts-nonsymmetrictruss-message-1221x439.png)

![](/images/csdirector-cstruss/resources/images/ts-symmetricupdatesimpossible.png)

**Related Topics**